??互搏体育??

Service Hotline: 021-56728844 51693244 Click here to send me a message
??互搏体育?? page Company Profile Products News Center Leave message Applications Download Blog Center contact us
Category: reducer | gear reducer | stepless speed reducer | cycloid reducer | gear steering box | screw lifter | worm gear reducer | planetary reducer |
R series helical gear hard tooth surface reducer
S series cylindrical worm reducer
K series arc bevel gear hard tooth surface reducer
F series parallel shaft helical gear reducer
MB, MBN series planetary cone disc stepless speed changer
XBJXJ series cycloid reducer
WB series miniature cycloid reducer
G series single-phase three-phase gear reduction motor
Z series hard toothed cylindrical gear reducer
T series spiral bevel gear steering box
ARA series spiral bevel gear steering box
HD spiral bevel commutator
SWL worm gear screw lift
JWM screw lift
RV series worm reducer
WP cast iron worm gear reducer
PL series precision planetary reducer
PF precision planetary reducer
PS series precision planetary reducer
PW series precision planetary reducer
HB standard industrial gearbox
MC large gear reducer
CW circular arc cylindrical worm reducer
DBY / DCY series conical cylindrical gear reducer
Cycloidal pinwheel reducer principle
次 Tag: Principle of reducer, Principle of cycloidal pinwheel reducer

1. Its principle is like two silver coins, one stationary and the other leaning on its side to turn. When the rotating coin turns from one point back to the original point, it has already turned two turns instead of one.
2. As long as the oil is normal in daily life.
3. The diagram is not easy to draw, let me explain. It consists of gears, and the combination of dynamic and static gears is not engaged outside like silver coins. Instead, one outer side and the other inner side mesh to form a group, which saves space, and even multiple groups can be stacked in a cylinder. The input and output shafts of the cylinder are on the same center, but the internal gears are not concentric. The driving wheel is smaller than the driven wheel and swings along the axis while rolling along the side. Drive the driven wheel to roll; the driven wheel drives the next driving wheel to swing along the shaft, so as to reach the output shaft. The number of teeth and the number of gears in each group determine the gear ratio.
4. Suitable for any machinery installed vertically. Such as mixing paddles and rakes.
5. It is easy for the seal to leak oil, just change the seal.
When changing, just remove the motor screws, do not remove the reducer screws. Remove the fan blade cover after removing it. Rotate the fan while pulling out the motor. Rotate the fan when changing the rear-mounted motor.
Also the oil pump is prone to problems. Transparent oil pipes are prone to oil leakage. Be sure to remember the direction mark of each gear when disassembling the reducer so that it can be replaced.


Close this page 】 【 Print this page
Previous: MB CVT Next post: The solution to the excessive heat of the cycloid pin wheel reducer
Copyright ? 2009-2012 Shanghai Yijie Transmission Machinery Co., Ltd. <br /> Address: Pudu Industrial Park, Xidu, Fengxian District, Shanghai Postcode: 201401 Tel: 021-556728844 51693244 Fax: 021-666531144 Email: sh-yijie@163.com
Shanghai ICP No. 11041404
七乐彩 欢乐拼三张 真人游戏平台注册 欢乐拼三张